Skip to main content access modal is here
Digital Ink Technology

LED curable inks

LED curable inkjet inks from Digital Ink Technology are formulated to cure under light-emitting diode lamps, most often at a wavelength of 395 nm. The drop changes from liquid to a solid film as soon as the light reaches it, so prints can be handled without a long drying time. This ink type is stocked by Sign to Badge Solutions.

Wide-format inkjet printer applying colourful ink to a roll of media

Key points

1Cures under LED lamps

The usual target wavelength is 395 nm. Digital Ink Technology can also formulate for other LED wavelengths when a printer uses a different lamp.

2Ready to handle after curing

Because the ink is cured by light rather than left to evaporate, finished work can usually be stacked, finished or packed sooner than with many solvent or water-based systems.

3Lower heat than mercury-arc UV

LED lamps give off less heat than traditional mercury-arc UV lamps, which helps when you are printing onto thinner films, certain plastics or other heat-sensitive materials.

4Built for major printhead types

Formulations are offered for low-viscosity and high-viscosity printheads from major manufacturers. The right match depends on the head, the ink system and the printer’s curing set-up.

5Flatbed, single-pass and roll-to-roll

The same ink family can be tuned for scanning flatbeds, higher-throughput single-pass lines and roll-to-roll graphics, rather than being limited to one machine style.

6A practical alternative to mercury-arc UV

Many printers move to LED curing to reduce lamp replacement, energy use and heat in the print zone. LED systems also avoid mercury lamps and the ozone those lamps can generate.

Typical uses

LED curable inks are widely used where an instantly cured film is useful and the substrate may not tolerate a hot mercury lamp.

  • Flatbed signs and display
  • Roll-to-roll graphics
  • Single-pass production lines
  • Heat-sensitive films and plastics
  • Direct-to-object work

Storage and handling

UV and LED curable inks are reactive. Digital Ink Technology recommends storing them between 5 °C and 40 °C, away from direct sunlight and other UV sources, ideally in the original outer carton. Ink that has been frozen, overheated or left in strong light can change viscosity or begin to polymerise, and should not be put through a printhead. Keep storage areas well ventilated, as a slight odour can still migrate through closed containers.

Related products

Other Digital Ink Technology pages in this range. Custom ink development is available if a stocked formulation is not the right fit.

  • Digital Ink Technology

    UV curable inks

    Inks formulated to cure under mercury-arc UV lamps, where a broader light spectrum is useful or an existing UV system is already in place.

    View page - UV curable inks
  • Digital Ink Technology

    Eco-solvent inks

    Lower-VOC solvent inks for wide-format vinyl work such as banners, signage and vehicle wraps, with a milder odour than full solvent inks.

    View page - Eco-solvent inks
  • Digital Ink Technology

    Primers

    Wipe-on and jettable primers that help inks adhere to difficult substrates. The right primer depends on the ink and the material.

    View page - Primers
  • Digital Ink Technology

    Custom OEM inks

    Custom ink engineering and manufacturing for OEM and industrial printers, from sample batches through to scaled production.

    View page - Custom OEM inks

See all Digital Ink Technology

See UV LED printers

Interested in LED curable inks? This ink type is stocked by Sign to Badge Solutions. Tell us your printer and application and we will help you from there.

Request a Quote

or call 07 3412 0285

Back to top